Search found 3 matches

by MisterPanda
Tue Apr 19, 2016 4:53 pm
Forum: Hardware
Topic: Adding an Openbuilds Openrail Y axis to a Taz 3/4/5
Replies: 219
Views: 40431

Re: Adding an Openbuilds Openrail Y axis to a Taz 3/4/5

Thanks for the mods, piercet! I used your "3mm" etched tall extruder body from thingiverse too. IMG_1623.JPG The Y-axis looks great. Because of taxes and work, I haven't printed yet -- only ran a couple tests without filament. I have printed after completing the X-axis mod installed and it was super...
by MisterPanda
Thu Oct 23, 2014 8:42 pm
Forum: KITTAZ
Topic: Kittaz build finished - comments and questions
Replies: 2
Views: 1629

Re: Kittaz build finished - comments and questions

Thanks for the feedback! I probably should have said that the build was a lot of fun despite getting stuck a few times. Had some trouble with tension between the x-axis rods and the z-drive. Not sure where I went wrong -- the plastic parts are a very tight fit in general and I may have tightened thi...
by MisterPanda
Thu Oct 23, 2014 8:27 am
Forum: KITTAZ
Topic: Kittaz build finished - comments and questions
Replies: 2
Views: 1629

Kittaz build finished - comments and questions

Hello, everyone! Just finished my Kittaz successfully (first 3D printer too). My day job is related to video post production -- I have little experience with building things, electronics, etc. I thought I would be better at printing if I knew how every piece fit together, so I bought the kit. First:...