Search found 2 matches

by Kcapra
Wed May 15, 2013 1:47 pm
Forum: Hardware
Topic: Printer is extruding VERY SLOW
Replies: 4
Views: 2048

Re: Printer is extruding VERY SLOW

Thank you for the information. It turns out that in Pronterface, there is a setting that for ABS should be at 300 mm/min, and for some reason mine got switched to 10. The one change made all the difference.
by Kcapra
Sat May 11, 2013 7:23 am
Forum: Hardware
Topic: Printer is extruding VERY SLOW
Replies: 4
Views: 2048

Printer is extruding VERY SLOW

I was doing a print that was estimated to last around 2 hours. About halfway through I paused the printer, then resumed an hour later. Now the extruder is running very slow. I cooled everything down and rebooted to see if that would help, but after starting it up again, it is still taking 20 seconds...