Search found 8 matches

by nalby
Fri Nov 16, 2018 7:54 am
Forum: Hardware
Topic: Taz 5 + BLTouch [Project]
Replies: 101
Views: 17824

Re: Taz 5 + BLTouch [Project]

AllenBW

Thanks it works great, all I had to do is adjust my e_steps and z_offset
by nalby
Mon Nov 12, 2018 5:20 pm
Forum: Hardware
Topic: Taz 5 + BLTouch [Project]
Replies: 101
Views: 17824

Re: Taz 5 + BLTouch [Project]

that was it thanks
by nalby
Tue Nov 06, 2018 12:54 pm
Forum: Hardware
Topic: Taz 5 + BLTouch [Project]
Replies: 101
Views: 17824

Re: Taz 5 + BLTouch [Project]

Hi I just installed the bltouch on my taz5, with a bit of tweaking I have it working pretty good. Thanks for the sketch. One question right now it's doing 12 points and takes forever is there a way to speed it up and do 9 points?

thanks jim
by nalby
Tue Nov 06, 2018 11:21 am
Forum: Hardware
Topic: Taz4-5 upgrade
Replies: 1
Views: 755

Taz4-5 upgrade

I started with a taz4 upgraded to a e3d titan areo , running taz 5 firmware, now I would like to install a bltouch, I need to know what to change in the firmware for the bltouch and my esteps for the titan. Any help would be great



thanks Jim
by nalby
Sat Jun 18, 2016 8:45 am
Forum: Hardware
Topic: Upgraded TAZ w/ Lulzbot Mini Parts & Cable Carrier Chains
Replies: 20
Views: 7831

Re: Upgraded TAZ w/ Lulzbot Mini Parts & Cable Carrier Chains

Techsavvy34, I really like your mods would it be possible to post your g-code for the wiper. I think i'll start with this then get into the bed leveling.



Thanks Jim
by nalby
Sun Jan 11, 2015 7:23 am
Forum: LulzBot TAZ
Topic: 2nd extruder control
Replies: 2
Views: 855

Re: 2nd extruder control

Thanks that helped a lot, but I still would like to have a setting on the lcd for each extruder
by nalby
Tue Jan 06, 2015 5:11 pm
Forum: LulzBot TAZ
Topic: 2nd extruder control
Replies: 2
Views: 855

2nd extruder control

I can make the first extruder extrude but is there a way to have the second extruder extrude from the lcd controller
by nalby
Tue Jan 06, 2015 10:39 am
Forum: Hardware
Topic: Auto-Leveling
Replies: 28
Views: 9920

Re: Auto-Leveling

Techsavvy34

How does the Proximity Sensor work? doesn't it need to sense metal? also how would you go about wiring it to a taz4 ( where would you get the + , - 5v from )