Search found 4 matches

by Tom_Neverwinter
Wed Sep 11, 2013 2:15 pm
Forum: Hardware
Topic: Budaschnozzle 2.0 PLA Fix
Replies: 31
Views: 20469

Re: Budaschnozzle 2.0 PLA Fix

This is a terribly designed piece. once any plastic gets on it your screwed. my thermistor failed attempting to fix leak. and once the thermistor fails you cannot repair it. the wiring is crimped together, this is garbage. impossible to replace or fix without drilling and using pliers on the wiring....
by Tom_Neverwinter
Sun Aug 18, 2013 2:44 pm
Forum: Hardware
Topic: Budaschnozzle 2.0 PLA Fix
Replies: 31
Views: 20469

Re: Budaschnozzle 2.0 PLA Fix

Why is this not done to the heater block right off the bat!!! after using my new hot end, for a week now after finally hooking it all up, I notice that the extra material dripping down my barrel is actually a problem and a known problem at that. so after reading through the forum I find this solutio...
by Tom_Neverwinter
Wed Jul 31, 2013 4:14 pm
Forum: Hardware
Topic: Pololu pot Tuning
Replies: 4
Views: 3393

Re: Pololu pot Tuning

That did not answer my question.
I want the science and math.

If I wanted to just mess with it, I would do it that way.

(fact; I can measure current with a screwdriver.)
by Tom_Neverwinter
Wed Jul 31, 2013 11:58 am
Forum: Hardware
Topic: Pololu pot Tuning
Replies: 4
Views: 3393

Pololu pot Tuning

Ok, I'm building a 3d printer, I have lulzbot stepper motors rated current (A) 1.5 Source;(http://www.lulzbot.com/?q=products/nema-17-stepper-motors) and lulzbot pololus (came preset at 0.4V /1Amp Source;(http://www.lulzbot.com/?q=products/pololu-a4988-stepper-motor-driver-assembled-rohs) but what I...