Search found 3 matches

by kirispupis
Sat May 07, 2016 10:49 pm
Forum: Software
Topic: Cura not merging for dual extrusion
Replies: 5
Views: 1340

Re: Cura not merging for dual extrusion

Thanks! It looks like the default y value was set to -50. When I set it to 50 then it worked.
by kirispupis
Sat May 07, 2016 8:02 pm
Forum: Software
Topic: Cura not merging for dual extrusion
Replies: 5
Views: 1340

Cura not merging for dual extrusion

I just installed the dual extruder and have not been able to get the calibration squares to print correctly. I did the following. - Installed Cura 19.12 - Set the extruder to the dual extruder v2 and flashed the firmware per the instructions - Loaded the inner square first, then the outer square - L...
by kirispupis
Wed Jan 06, 2016 10:46 pm
Forum: Filament
Topic: Flexystruder v2 jamming...
Replies: 29
Views: 9485

Re: Flexystruder v2 jamming...

I just had this problem too. I had to take apart the entire Flexystruder v2 to unjam it. I used the red Ninjaflex sold on Lulzbot.com. What I found is that the wheel that pulls the filament in scrapes it enough that the filament breaks apart and becomes too large to pull back through the hole. It lo...