Search found 5 matches

by Rhombus
Mon Aug 12, 2019 8:54 am
Forum: LulzBot TAZ
Topic: Taz 6 Probing Problem
Replies: 3
Views: 52

Re: Taz 6 Probing Problem

You were right. I knew it was going to be embarrassing simple. ;) Thanks for taking the time to give me a hint!

Ian
by Rhombus
Sun Aug 11, 2019 5:16 pm
Forum: LulzBot TAZ
Topic: Taz 6 Probing Problem
Replies: 3
Views: 52

Taz 6 Probing Problem

I'm Stumped, maybe someone can help point me the right direction. For whatever reason the G29 probing sequence has started failing on the second touch point. It initially descends, touches the pad, moves up slightly and when I expect it to descend again to fine tune the Z value it doesnt. It fails a...
by Rhombus
Mon Jul 04, 2016 3:58 pm
Forum: LulzBot TAZ
Topic: Taz 6 temperature calibration
Replies: 3
Views: 1458

Re: Taz 6 temperature calibration

Thanks for the response Frank. I will check the thermistor type. I also sent the question to AO support and I got the following response. I wanted to post it in case it is useful for someone else. I have not yet tried what they suggested. I wanted to brush up a little on PID controllers before I did...
by Rhombus
Mon Jul 04, 2016 2:33 pm
Forum: Hardware
Topic: A Strategy for Obtaining Great Prints
Replies: 40
Views: 63324

Re: A Strategy for Obtaining Great Prints

I really appreciate you taking the time to put together a guide like this. It is very helpful for new people like me. I did have one question however. During the part where you reduce the temperature 5 deg and extrude 50mm to see if it extrudes well, could you describe what you mean by "well"? Does ...
by Rhombus
Thu Jun 30, 2016 4:18 pm
Forum: LulzBot TAZ
Topic: Taz 6 temperature calibration
Replies: 3
Views: 1458

Taz 6 temperature calibration

I apologize if this has been covered. I searched the board but the search capabilities are pretty lame. My prints have been delaminating even at some pretty high temperature settings for a particular material, so I measured the hot end with my Fuke 87V's thermocouple by pressing it against the hot e...