Search found 4 matches

by rcpongo
Mon Oct 15, 2018 1:05 pm
Forum: Software
Topic: Issues with prints pausing after Cura and firmware update
Replies: 20
Views: 1296

Re: Issues with prints pausing after Cura and firmware update

Thanks, I'll install that version tonight when I get home and try to run through some prints. I'll update with the results I get. Edit: managed to get in about 4 hours of printing with no pauses. (2 different prints) These were prints with multiple objects, which were the ones that were pausing for ...
by rcpongo
Sun Oct 14, 2018 4:02 pm
Forum: Software
Topic: Issues with prints pausing after Cura and firmware update
Replies: 20
Views: 1296

Re: Issues with prints pausing after Cura and firmware update

Just came here looking to post the same issue. In my case, I recently installed version 3.2.27, and this also required me to update the firmware since the new version did not see my Mini. The version I had been using before was ancient, but I've never had any issues until this update. The last few d...
by rcpongo
Thu Sep 29, 2016 9:34 pm
Forum: LulzBot Mini
Topic: Cracked piece above my extruder. (The idler?)
Replies: 9
Views: 1582

Re: Cracked piece above my extruder. (The idler?)

Thanks,

I will check on the warranty first because it is probably within that.
by rcpongo
Wed Sep 28, 2016 10:32 pm
Forum: LulzBot Mini
Topic: Cracked piece above my extruder. (The idler?)
Replies: 9
Views: 1582

Cracked piece above my extruder. (The idler?)

I went to replace my filament, and saw that this piece is cracked in half. I have a few questions regarding this. I have an .stl of the piece, and it appears that it will hold in place while I can print a replacement piece, but I only print in PLA so this is all I have on hand. Is PLA sufficient for...