Search found 8 matches

by Spacemonkey1023
Sun Aug 12, 2018 7:59 pm
Forum: LulzBot TAZ
Topic: Dual Extruder V3 - why angle the filament channel?
Replies: 15
Views: 2114

Re: Dual Extruder V3 - why angle the filament channel?

Thanks, I'll give that a try!
by Spacemonkey1023
Fri Jul 06, 2018 10:45 pm
Forum: LulzBot TAZ
Topic: Dual Extruder V3 - why angle the filament channel?
Replies: 15
Views: 2114

Re: Dual Extruder V3 - why angle the filament channel?

Has anybody had any luck with replacing the heat sink fans? I used the Noctua NF-A4x20 5V with 9.4 cm3 flow, but I'm still getting heat creep with PLA. I'm thinking about replacing the other fans with Noctuas as well.
by Spacemonkey1023
Mon Mar 26, 2018 7:22 pm
Forum: Hardware
Topic: TAZ Dual V3 jams
Replies: 5
Views: 1006

Re: TAZ Dual V3 jams

I've been doing mostly PLA with the new extruder, haven't gotten to PETG yet. I'm running into the same issue and from what I'm learning reading the forums I think it's heat creep that's affecting the extruders. I'm going to try swapping fans and seeing what happens. Anyway here are the retraction s...
by Spacemonkey1023
Sun Mar 25, 2018 8:28 pm
Forum: LulzBot TAZ
Topic: Dual Extruder V3 - why angle the filament channel?
Replies: 15
Views: 2114

Re: Dual Extruder V3 - why angle the filament channel?

How you you replace the heat sink fan? I'm pretty sure I'm having the heat creep issue as well?
by Spacemonkey1023
Fri Mar 23, 2018 6:15 pm
Forum: Hardware
Topic: Cannot Adjust Z Offset After Installing Dual Extruder V3
Replies: 9
Views: 1086

Re: Cannot Adjust Z Offset After Installing Dual Extruder V3

Please post the resolution to this when it's finally found. I keep messing with mine but I'm unsure if it's actually doing anything. I don't hear stepper changes when I change my zoffset. It's working alright, but I am certain I am a bit off. For the temporary fix, I moved my v3 over the center of ...
by Spacemonkey1023
Mon Mar 19, 2018 6:25 pm
Forum: LulzBot TAZ
Topic: Dual Extruder V3 - why angle the filament channel?
Replies: 15
Views: 2114

Re: Dual Extruder V3 - why angle the filament channel?

I just wish there was an easier way to load the filament. It's pretty much a blind procedure and if I'm unlucky it takes forever until the filament finds its way into the channel just right.
by Spacemonkey1023
Sun Mar 11, 2018 5:11 pm
Forum: Hardware
Topic: Cannot Adjust Z Offset After Installing Dual Extruder V3
Replies: 9
Views: 1086

Cannot Adjust Z Offset After Installing Dual Extruder V3

Hi, everybody! I just installed the Dual Extruder V3 (had a V2 previously) and now I'm having issues setting the Z offset. When I try to set it in hardware nothing really happens, no matter what I set the offset too. I don't hear the stepper motors moving like I used to, and no changes I can feel wh...