Search found 6 matches

by sdhowar1
Wed Jul 11, 2018 10:08 pm
Forum: Hardware
Topic: Aerosteuder clogs oh my!
Replies: 1
Views: 182

Aerosteuder clogs oh my!

Depending upon the filament you use, the aerostruder can have a heat creep problem which ultimately results in clogs. In the standard single struder, cold pulls are king. In the dual extruder cold pulls are difficult but possible. In the aerostruder it is physically impossible. The best method I hav...
by sdhowar1
Wed Jul 11, 2018 10:03 pm
Forum: Hardware
Topic: Firmware Update on Taz 6 / aerostruder results in no boot screen and no usb comms
Replies: 4
Views: 286

Re: Firmware Update on Taz 6 / aerostruder results in no boot screen and no usb comms

So I resolved the issue based off of an old forum for RAMPS, the namesake of the RAMBO board. It was not fuses. That was the path that tech support sent me down as well. The key clues is that both the light switch was illuminated and the fan was spinning on the print head. Power was going theough bo...
by sdhowar1
Mon Jul 09, 2018 6:14 pm
Forum: Hardware
Topic: Firmware Update on Taz 6 / aerostruder results in no boot screen and no usb comms
Replies: 4
Views: 286

Re: Firmware Update on Taz 6 / aerostruder results in no boot screen and no usb comms

I have used this cable before. Also, wouldn't the screen still appear with the standard 'Marlin vX.XX.XX'?
by sdhowar1
Thu Jul 05, 2018 11:54 pm
Forum: Hardware
Topic: Firmware Update on Taz 6 / aerostruder results in no boot screen and no usb comms
Replies: 4
Views: 286

Firmware Update on Taz 6 / aerostruder results in no boot screen and no usb comms

Hello. I just updated my lulzbot taz 6 firmware to run with my new aerostruder. I followed the same process I have done before with my dualstruder and flexstruder. But this time the screen froze. The cura update claimed usb communications failed. I waited an hour hoping the process would return but ...
by sdhowar1
Wed Oct 18, 2017 8:44 pm
Forum: Software
Topic: Details garbled when X&Y axis movement is small
Replies: 2
Views: 389

Re: Details garbled when X&Y axis movement is small

I ran the dimensional accuracy. This seems a bit off to me. Is my machine rocking or is something rubbing?
image1.JPG
image2.JPG
by sdhowar1
Tue Oct 17, 2017 12:29 pm
Forum: Software
Topic: Details garbled when X&Y axis movement is small
Replies: 2
Views: 389

Details garbled when X&Y axis movement is small

Hey all, I'm running the latest Cura with the LULZBOT Taz 6 with 0.5mm standard single nozzle. I've noticed that when I print objects that require small amounts of X\Y movement (as in the peak of a mountain or the crow's nest of a clipper ship) the details are marred. The plastic looks twisted rathe...