Search found 5 matches

by oldtownglass
Tue Feb 20, 2018 11:38 pm
Forum: Hardware
Topic: Aerostruder Issues
Replies: 3
Views: 744

Re: Aerostruder Issues

Here are the additional photos.
IMG_1717.jpg
IMG_1718.jpg
IMG_1719.jpg
IMG_1723.jpg
by oldtownglass
Tue Feb 20, 2018 11:37 pm
Forum: Hardware
Topic: Aerostruder Issues
Replies: 3
Views: 744

Aerostruder Issues

Just installed my new AEROstruder Tool Head on my Taz 6. 1. With the standard Taz 6 feeder tube the tube sits directly against the wiring harness. The same issue happens with an overhead spool feeder. Any suggestions? It appears that the wires will wear quickly against the filament. The install docu...
by oldtownglass
Mon Jan 15, 2018 10:03 am
Forum: Filament
Topic: INOVA 1800 & Taz 6, issue with 3D Benchy
Replies: 5
Views: 1134

Re: INOVA 1800 & Taz 6, issue with 3D Benchy

I have tried the Z-axis offset with Village Plastics PLA and seem to be getting better results. I am going to try and with other Filament types. The factory setting was -1.2. After a bit of trial and error I am at -1.3 with the PLA. As I have been doing a number of test prints, I noticed that the no...
by oldtownglass
Thu Dec 28, 2017 4:48 pm
Forum: Filament
Topic: INOVA 1800 & Taz 6, issue with 3D Benchy
Replies: 5
Views: 1134

Re: INOVA 1800 & Taz 6, issue with 3D Benchy

Thanks for the suggestions. I tried to print again and used a very thin layer of UHU gluestick. Was called out on INNOVA's website. I can try Elmer's too. 3D Benchy: The INNOVA 1800 (Lulzbot Green) still peels slightly and then the nozzle caught the print when it got to the roof. IMG_0975.jpg I swit...
by oldtownglass
Wed Dec 27, 2017 12:28 pm
Forum: Filament
Topic: INOVA 1800 & Taz 6, issue with 3D Benchy
Replies: 5
Views: 1134

INOVA 1800 & Taz 6, issue with 3D Benchy

I am trying to print with INOVA 1800 on my new Taz 6. Have printed multiple test prints with PLA and nvent. Running into an issue printing 3D Benchy with INOVA 1800. Attached photos shows the last two attempts. The print gets attached to the nozzle and starts pulling it. This is my 7th or 8th print ...