Search found 5 matches

by hgrinolds
Tue Aug 21, 2018 4:18 pm
Forum: Hardware
Topic: Dual Extruder V3 Nozzle Wiping and Auto Leveling
Replies: 3
Views: 410

Re: Dual Extruder V3 Nozzle Wiping and Auto Leveling

This may redundant but I did not see the other attachments. Here they are:
by hgrinolds
Tue Aug 21, 2018 4:15 pm
Forum: Hardware
Topic: Dual Extruder V3 Nozzle Wiping and Auto Leveling
Replies: 3
Views: 410

Re: Dual Extruder V3 Nozzle Wiping and Auto Leveling

Thank you for looking at the post. I have attached the information for the CURA, TAZ6-V3 and Marlin firmware versions. Also the g-Code beginning and ending are pictured from the Cura Configure - Printer settings. The results from running a M115 command are also included. I continued to look into the...
by hgrinolds
Mon Aug 20, 2018 11:23 am
Forum: Software
Topic: Bad prints!
Replies: 4
Views: 240

Re: Bad prints!

I have found that driving the TAZ6 by USB can result in pauses. Pauses can cause some of the extra material to ooze out.
The pausing depends on the computer and what else it may be doing. I suggest you use the g-code file and drive the TAZ via the SD card if you are not already doing that.
by hgrinolds
Sun Aug 19, 2018 4:25 pm
Forum: Software
Topic: Changing Bed Dimensions for 1.1.8.62
Replies: 0
Views: 147

Changing Bed Dimensions for 1.1.8.62

I have a Dual V3 extruder with the TAZ-6. In auto-leveling, the nozzles come too close to the washer screws. Thus, I want to change the bed dimensions (left and right-probe; back and front-probe). However, I cannot find a Marlin/Lulzbot source code that works with the configuration.h and configurati...
by hgrinolds
Fri Aug 10, 2018 1:24 pm
Forum: Hardware
Topic: Dual Extruder V3 Nozzle Wiping and Auto Leveling
Replies: 3
Views: 410

Dual Extruder V3 Nozzle Wiping and Auto Leveling

I purchased a Dual Extruder V3 with a TAZ6 printer last April. I am new to printing so I used the single extruder to better learn the different materials. This week I installed the V3, upgraded the firmware to 1.1.8.62 (Marlin on the LCD) and updated the Cura Edition to 3.2.23 version. I did not hav...