Search found 5 matches

by cwiggs
Fri Jun 22, 2018 2:37 pm
Forum: Hardware
Topic: Printer leaving beads of plastic on the outer and inner shell
Replies: 3
Views: 200

Re: Printer leaving beads of plastic on the outer and inner shell

Ahh, I had wondered about that. I'll try that post the results.
by cwiggs
Fri Jun 22, 2018 1:33 pm
Forum: Hardware
Topic: Printer leaving beads of plastic on the outer and inner shell
Replies: 3
Views: 200

Printer leaving beads of plastic on the outer and inner shell

Hello all. I've recently had issues with my Lulzbot Taz 6 leaving little beads of plastic on the outer surface of some parts I've done. The printer will be in the middle of laying down either an outer or inner shell layer, when it will pause for 1-2 seconds, leaking out plastic and leaving a small b...
by cwiggs
Wed May 30, 2018 11:03 am
Forum: Hardware
Topic: Taz 6 v3 Dual Extruder Leveling Issue
Replies: 3
Views: 407

Re: Taz 6 v3 Dual Extruder Leveling Issue

Thanks! Wiping it down with the Scotch Brite pad just before each touch on the leveling plates did the trick.
by cwiggs
Wed May 09, 2018 11:23 am
Forum: Hardware
Topic: Taz 6 v3 Dual Extruder Leveling Issue
Replies: 3
Views: 407

Re: Taz 6 v3 Dual Extruder Leveling Issue

https://www.youtube.com/watch?v=k_40Ii0lKkc

This is a video I found on Youtube (not my printer) of someone having the same issue (albeit with a single head extruder instead of the double)
by cwiggs
Wed May 09, 2018 11:20 am
Forum: Hardware
Topic: Taz 6 v3 Dual Extruder Leveling Issue
Replies: 3
Views: 407

Taz 6 v3 Dual Extruder Leveling Issue

Hello all. I recently upgraded my company Taz 6 to have the v3 Dual Extruder. I followed the steps on the Lulzbot website carefully for installation, and for the first couple prints it seemed to be working fine. However, lately its been having trouble leveling properly. When the left hand extruder (...