Search found 6 matches

by Tobotron
Mon Oct 08, 2018 11:40 am
Forum: Software
Topic: Issues with prints pausing after Cura and firmware update
Replies: 20
Views: 2260

Re: Issues with prints pausing after Cura and firmware update

I actually took the opportunity to buy a raspberry pi and install octoprint for untethered printing .

It’s amazing! I would heartily reccomend it as it also allows webcam monitoring and printer control over the local network !
No more stalls and no more burning out my monitor
by Tobotron
Tue Oct 02, 2018 4:03 pm
Forum: Software
Topic: Issues with prints pausing after Cura and firmware update
Replies: 20
Views: 2260

Re: Issues with prints pausing after Cura and firmware update

I’ve reverted to a previous version of cura (which runs more smoothly
Anyway) and tomorrow night I
May try reverting to the firmware
That came with he printer, which I seemed to have no issues with before the update
by Tobotron
Tue Oct 02, 2018 4:01 pm
Forum: Software
Topic: Issues with prints pausing after Cura and firmware update
Replies: 20
Views: 2260

Re: Issues with prints pausing after Cura and firmware update

Ok after some messing about this evening with different installs ect I’ve now narrowed the problem down to this , if the screen saver or display sleep are activated (OS X) the printer stops nearly 2 minutes after and resumes when woken Hdd sleep is set to ‘never’ If I disable screensaver and/or disp...
by Tobotron
Tue Oct 02, 2018 1:42 am
Forum: Software
Topic: Issues with prints pausing after Cura and firmware update
Replies: 20
Views: 2260

Re: Issues with prints pausing after Cura and firmware update

It’s quite frustrating , I’ll try a couple of other files tonight and report back
by Tobotron
Mon Oct 01, 2018 11:45 pm
Forum: Software
Topic: Issues with prints pausing after Cura and firmware update
Replies: 20
Views: 2260

Re: Issues with prints pausing after Cura and firmware update

No response as of yet, I cleared my cache and tried a rockyupis which ran fine, it got a bit late last night so I’ll try a few other models and see what happens
by Tobotron
Mon Oct 01, 2018 10:09 am
Forum: Software
Topic: Issues with prints pausing after Cura and firmware update
Replies: 20
Views: 2260

Re: Issues with prints pausing after Cura and firmware update

After nearly 9 months of flawless operation I upgraded cura and my firmware today and I too have the same issue , different heights in the prints . It’s happening on every print so far :-((