Search found 5 matches

by Shdwdrgn
Wed Aug 21, 2019 3:46 pm
Forum: LulzBot TAZ
Topic: Auto-leveling presses down bed corners
Replies: 3
Views: 341

Re: Auto-leveling presses down bed corners

@mwester -- Thanks for the reply! OK, scotchbrite pad sounds good, I'll grab one to bring in tomorrow. I did actually check all four 'washers' (I assume that's the metal discs on the corners?) and they are solid so I didn't try tightening any further. The test print finished, and the quality looks a...
by Shdwdrgn
Wed Aug 21, 2019 3:37 pm
Forum: LulzBot TAZ
Topic: Auto-leveling presses down bed corners
Replies: 3
Views: 341

Re: Auto-leveling presses down bed corners

I've been thinking about this problem from the perspective of an electrical issue and realized I could see a light grey film of corrosion on the corner pads. I don't have much to work with here, but took a pencil eraser to the metal surfaces to give them a bit of a cleaning. Then I homed the head an...
by Shdwdrgn
Wed Aug 21, 2019 1:57 pm
Forum: LulzBot TAZ
Topic: Auto-leveling presses down bed corners
Replies: 3
Views: 341

Auto-leveling presses down bed corners

Sorry if this has been answered already, I wasn't having any luck with searches. We have a TAZ 6, completely stock with a single extruder head. It has been working great for the past few years but recently problems with the prints have been showing up. I'm going to start with the auto-leveling issue...
by Shdwdrgn
Mon Apr 01, 2019 2:21 pm
Forum: Software
Topic: Print issues when moving from Cura PE 21.08 to 3.2.27
Replies: 9
Views: 1195

Re: Print issues when moving from Cura PE 21.08 to 3.2.27

We are printing through the USB port -- either directly from Cura via the computer, or sending the job to OctoPrint which then runs the job through USB. Either way produced the same results for Cura 3.2 and 3.6, and the only way we get a smooth print is by using Cura 21LE (computer connected direct ...
by Shdwdrgn
Tue Mar 19, 2019 3:49 pm
Forum: Software
Topic: Print issues when moving from Cura PE 21.08 to 3.2.27
Replies: 9
Views: 1195

Re: Print issues when moving from Cura PE 21.08 to 3.2.27

I just joined the forum to ask about this same problem, but since there's already an ongoing thread I'll just chime in with "me too". We purchased a raspberry pi so I could set up OctoPrint to remote monitor our Taz 6, which requires the use of Cura 3.2 or higher. Prints that we have been repeating ...