Search found 5 matches
Search found 5 matches • Page 1 of 1
- Thu Oct 02, 2014 2:29 pm
- Forum: News and Announcements
- Topic: Free Blender Tutorial
- Replies: 3
- Views: 1393
Sorry but there isn't. This is a membership site and requires an email for registration. You can always unsubscribe after the tutorial if you don't want further contact.
I've been noticing the first 3 layers or so have a strange rippling on some of my prints. This happens on all my Taz's (3 of them) at one time or another. I just finished upgrading the X and Z axis parts and replaced the polymer bearings with ball bearing ones on one printer but it's still there. La...
I use a cheap Radio Shack soldering iron. Just file down the tip so it just barely fits the insert. Holding the insert in needle nose pliers I push the tip into it and give about 1/8 turn. The insert will just start to thread itself into the soft copper of the tip and hold it in place while you inst...
- Sat Jun 01, 2013 6:42 am
- Forum: Hardware
- Topic: Removing threaded extension on Budashnozzle1.0
- Replies: 2
- Views: 817
I too had that same problem. I ended up removing the entire assembly and unscrewing the damaged extension and block from the other (ceramic?) end. I ordered a new extension and block and transferred the old resistor and thermistor to the new block. I'm not looking forward to doing that again anytime...