Search found 4 matches

by Noah
Sun Jun 30, 2019 4:19 pm
Forum: LulzBot Mini
Topic: Groaning Rails...
Replies: 4
Views: 66

Re: Groaning Rails...

Could you give a bit more detail in regards to the groaning noise you are hearing? Is it the X, Y, or Z axis rods that are making a groaning noise?
by Noah
Sun Jun 23, 2019 2:01 pm
Forum: LulzBot Mini
Topic: Yet more questions, initial layer height?
Replies: 1
Views: 50

Re: Yet more questions, initial layer height?

The initial layer height in Cura is set to be thicker than the rest of the layers, this is to help with bed adhesion. If the first layer is thicker than the rest in your print it is nothing to be concerned about. However if you wanted to adjust the first layer to be as thick as the rest, you could d...
by Noah
Sun Jun 23, 2019 9:40 am
Forum: LulzBot Mini
Topic: Modular Print Bed on Mini 1.4?
Replies: 4
Views: 91

Re: Modular Print Bed on Mini 1.4?

The modular bed's metal plate heat pad helps disperse heat more evenly throughout the build plate which allows the entire build volume to be utilized to its full potential. You can also flip the glass surface to print on the bare glass for filaments that do better on glass like flexibles. If you are...
by Noah
Sun May 26, 2019 9:42 am
Forum: LulzBot Mini
Topic: Lulzbot Mini 1 first layer problems
Replies: 2
Views: 154

Re: Lulzbot Mini 1 first layer problems

Try making sure that the screws holding your Y-Axis bed frame to the printers frame are on nice and snug and that the X-axis is aligned. 1. First please raise your tool head off of the bed. If it already off of the bed, go to the next step. If the Z motors are bound up and will not allow you to move...