Search found 3 matches

by Malwolficus
Tue Aug 06, 2019 7:49 am
Forum: Software
Topic: Cura 3.6.13 consistent print failure due to E-
Replies: 4
Views: 373

Re: Cura 3.6.13 consistent print failure due to E-

My gcode is very similar to yours (a few extra lines). I'll just plan on manually editing the code - but it *would* be nice if Cura had an option for controlling the amount of retraction. Who can I suggest that to?
by Malwolficus
Mon Aug 05, 2019 11:44 am
Forum: Software
Topic: Cura 3.6.13 consistent print failure due to E-
Replies: 4
Views: 373

Cura 3.6.13 consistent print failure due to E-

We've had an abundance of print failures since upgrading to Cura 3.6.13 and we've noticed that it has *got* to be the filament extraction protocol. If, when the print is just starting, we quickly snap open the filament clasp and push the filament down until it stops, all prints work as expected. If ...
by Malwolficus
Thu Jun 06, 2019 12:50 pm
Forum: LulzBot TAZ
Topic: Taz 6 filament extrudes manually but not during printing
Replies: 1
Views: 242

Taz 6 filament extrudes manually but not during printing

Never seen this one before! If I use the built-in UI to move the extruder to extrude filament it comes out just fine. When I set up a print job it does not. And - the filement looks "chewed on" by the feeder gear! Any suggestions?