Search found 6 matches

by gehrig44
Thu Oct 25, 2018 2:48 pm
Forum: Software
Topic: Taz 4 settings
Replies: 5
Views: 1068

Re: Taz 4 settings

Does anyone know where to download the legazy version of Cura that works with Taz 4? Assuming it is still 21.08.
by gehrig44
Mon Mar 30, 2015 7:20 am
Forum: LulzBot TAZ
Topic: Small cylindrical parts printing oval
Replies: 3
Views: 808

Re: Small cylindrical parts printing oval

I tried tightening the belt that the extruder uses. Didn't seem to make a difference, and felt pretty tight. Debating if the bed belt is worth tightening..seems tight enough to me. When I print this part, I am printing 10 at a time. They are laid out in a circular pattern. I noticed that the parts f...
by gehrig44
Sat Mar 28, 2015 12:42 pm
Forum: LulzBot TAZ
Topic: Small cylindrical parts printing oval
Replies: 3
Views: 808

Small cylindrical parts printing oval

Hi, I am printing a very small cylindrical part. For some reason this part is coming out a bit oval. My layers are about .1mm and slowed down the print movements quite a bit. I am using the stock .35mm nozzle and PLA from lulzbot at recommended temps. Any suggestions would be much appreciated. I do ...
by gehrig44
Wed Sep 10, 2014 4:59 pm
Forum: Hardware
Topic: Filament breaking above idler on large prints
Replies: 6
Views: 2510

Re: Filament breaking above idler on large prints

I got a some Lulzbot PLA and haven't had any issues since. So, the filament I bought on amazon was indeed crap.
by gehrig44
Sun Sep 07, 2014 12:40 pm
Forum: Hardware
Topic: Filament breaking above idler on large prints
Replies: 6
Views: 2510

Re: Filament breaking above idler on large prints

Really? Just bought it on amazon. Seemed like just about every filament I looked at had mixed reviews. I'll order the Lulzbot brand as a comparison then.
by gehrig44
Sun Sep 07, 2014 9:41 am
Forum: Hardware
Topic: Filament breaking above idler on large prints
Replies: 6
Views: 2510

Filament breaking above idler on large prints

I just received my Taz 4 and small prints using PLA having been going pretty well. However, the plastic filament I am using keeps breaking on larger prints where the extruder needs to go near the end of the X+ plane. This is putting too much pressure on the filament and it just snaps. It breaks off ...