Search found 100 matches

by ritmopat
Fri Mar 22, 2019 4:09 pm
Forum: LulzBot TAZ
Topic: First few layers
Replies: 14
Views: 1485

Re: First few layers

don't mess with the tension..try the old cura first!
by ritmopat
Fri Mar 22, 2019 4:08 pm
Forum: LulzBot TAZ
Topic: First few layers
Replies: 14
Views: 1485

Re: First few layers

I would give it a try with the old cura the one that came with the printer some people are having problems I see with the new cura....I use the cura that came with my printer for now ..I did have some edge layer issues with the newer cura myself so rather then mess for now I went back to the older v...
by ritmopat
Fri Mar 22, 2019 3:12 pm
Forum: LulzBot TAZ
Topic: First few layers
Replies: 14
Views: 1485

Re: First few layers

which version of cura are you running
by ritmopat
Fri Mar 22, 2019 2:59 pm
Forum: LulzBot TAZ
Topic: First few layers
Replies: 14
Views: 1485

Re: First few layers

what filament are you printing?
by ritmopat
Fri Mar 22, 2019 2:55 pm
Forum: LulzBot TAZ
Topic: cura first layer
Replies: 3
Views: 370

Re: cura first layer

well I 'went' for it and got my first border line to measure ...cura fast print says initial layer.43 got it to .42 close enough for gov.work....
went from my initial offset of -1.6 to -1.3...1st layer went from .31mm to the .42mm
by ritmopat
Fri Mar 22, 2019 1:06 pm
Forum: LulzBot TAZ
Topic: cura first layer
Replies: 3
Views: 370

Re: cura first layer

right now I'm getting apx .3mm the first layer (I had to adjust my z axis left screw rod apx 1mm. to get better readings from the 'sensor') maybe that's why? maybe see if I can get the .43 layer on the z offset .. give it a try? ..any thoughts other then 'go for it'....
by ritmopat
Fri Mar 22, 2019 12:20 pm
Forum: LulzBot TAZ
Topic: cura first layer
Replies: 3
Views: 370

cura first layer

cura shows polylite first layer (fast print) at .43mm should the first layer be .43mm then? thanks
by ritmopat
Thu Mar 21, 2019 9:45 am
Forum: LulzBot TAZ
Topic: wiper hand tool... free stl file
Replies: 1
Views: 319

Re: wiper hand tool... free stl file

I put a piece of 'emery' cloth on the backside ..after I get my good wipe and little 'drip' cleaned off I'll give the tip a swipe or two with the emery cloth side before it does the self leveling...I always wipe the tip with the wiper after each print!..I have the my 'wiper' tool velcor to the printer
by ritmopat
Thu Mar 21, 2019 9:11 am
Forum: Software
Topic: cura first layer
Replies: 0
Views: 435

cura first layer

cura shows first layer (fast print setting) for polylite pla at .425 Does that mean the first layer /outline should measure .425mm?.... if it's not should I raise the offset until it measures .425mm thanks!
by ritmopat
Sat Mar 16, 2019 1:06 pm
Forum: Hardware
Topic: How to get product support?
Replies: 3
Views: 459

Re: How to get product support?

what’s your issue?