# Align the print to the bed

**URL:** <https://forum.lulzbot.com/t/align-the-print-to-the-bed/4619>\
**Category:** Software\
**Created:** [February 24, 2017, 1:39am UTC](https://forum.lulzbot.com/t/align-the-print-to-the-bed/4619 "2017-02-24T01:39:27Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![myeager](https://avatars.discourse-cdn.com/v4/letter/m/f08c70/32.png) [@myeager](https://forum.lulzbot.com/u/myeager)\
**Post date:** [February 24, 2017, 1:39am UTC](https://forum.lulzbot.com/t/align-the-print-to-the-bed/4619/1 "2017-02-24T01:39:27Z")

</div>

Can anyone tell me how to align the print in Cura to the print bed on the Taz 6?

It is centered on the virtual image of the bed in Cura, but when you run the print, it is off center, about a half an inch towards the back of the bed rather than in the center.

---

<div class="post-metadata">

**Author:** ![Stonetrails](https://avatars.discourse-cdn.com/v4/letter/s/e480ec/32.png) [@Stonetrails](https://forum.lulzbot.com/u/Stonetrails)\
**Post date:** [December 16, 2020, 5:00pm UTC](https://forum.lulzbot.com/t/align-the-print-to-the-bed/4619/2 "2020-12-16T17:00:28Z")

</div>

Any luck getting this solved? I have the same issue…