# Bed temp after print

**URL:** <https://forum.lulzbot.com/t/bed-temp-after-print/3498>\
**Category:** LulzBot TAZ\
**Created:** [May 26, 2016, 8:28pm UTC](https://forum.lulzbot.com/t/bed-temp-after-print/3498 "2016-05-26T20:28:01Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Corr](https://avatars.discourse-cdn.com/v4/letter/c/f17d59/32.png) [@Corr](https://forum.lulzbot.com/u/Corr)\
**Post date:** [May 26, 2016, 8:28pm UTC](https://forum.lulzbot.com/t/bed-temp-after-print/3498/1 "2016-05-26T20:28:01Z")

</div>

Ok guys,

My TAZ 5 has developed a mind of its own.  
After a print our TAZ has decided to start parking the head at it max height and the bed is staying heated until reset.  
I am not sure if someone changed a setting somewhere but I cannot find where it is set to tell it to do this. We are currently using Cura to print. I don’t see any setting in the basic advanced or expert settings. There are a couple of plug-ins loaded but I don’t think that they are active.  
Anybody have any Ideas.

---

<div class="post-metadata">

**Author:** ![franksanderdo](https://avatars.discourse-cdn.com/v4/letter/f/ecc23a/32.png) [@franksanderdo](https://forum.lulzbot.com/u/franksanderdo)\
**Post date:** [June 1, 2016, 3:30pm UTC](https://forum.lulzbot.com/t/bed-temp-after-print/3498/2 "2016-06-01T15:30:07Z")

</div>

Hi Corr

It seems some body has changed your End-GCode.  
You can find that in the expert settings. Below you find the ones for my Mini.  
There the positions are slightly different 😉

 ![Screenshot 2016-06-01 18.27.50.png](https://us1.discourse-cdn.com/flex020/uploads/lulzbot/original/2X/7/72814d6ac400163c4268b84b230cdc64282bacae.png)