# Change models during printing

**URL:** <https://forum.lulzbot.com/t/change-models-during-printing/26955>\
**Category:** Community\
**Created:** [September 4, 2024, 6:32pm UTC](https://forum.lulzbot.com/t/change-models-during-printing/26955 "2024-09-04T18:32:14Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![robertbobert](https://avatars.discourse-cdn.com/v4/letter/r/13edae/32.png) [@robertbobert](https://forum.lulzbot.com/u/robertbobert)\
**Post date:** [September 4, 2024, 6:32pm UTC](https://forum.lulzbot.com/t/change-models-during-printing/26955/1 "2024-09-04T18:32:14Z")

</div>

Hello, I’m printing two items, but one item is lifting off the bed (heat issue possibly) is there a way to cancel the print of one item and continue with the other? Or should I just start over?

Thanks in advance,

RB

---

<div class="post-metadata">

**Author:** ![Wrathernaut](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/wrathernaut/32/13542_2.png) [@Wrathernaut](https://forum.lulzbot.com/u/Wrathernaut)\
**Post date:** [September 4, 2024, 6:48pm UTC](https://forum.lulzbot.com/t/change-models-during-printing/26955/2 "2024-09-04T18:48:56Z")

</div>

You can’t cancel individual objects unless you’re running through Octoprint. Cancel it, fix the cause of the lifting, and then try printing again.

---

<div class="post-metadata">

**Author:** ![robertbobert](https://avatars.discourse-cdn.com/v4/letter/r/13edae/32.png) [@robertbobert](https://forum.lulzbot.com/u/robertbobert)\
**Post date:** [September 5, 2024, 1:58pm UTC](https://forum.lulzbot.com/t/change-models-during-printing/26955/3 "2024-09-05T13:58:29Z")

</div>

That was my fear, thanks for the quick reply,

RB