Cura 14.09 Nesting questions

I have installed Cura 14.09 Lulzbot edition. Printing with a TAZ 3,4,5


  • I am attempting to nest parts on the bed. To optimize my bed space I often space parts about 1-2 mm apart. Cura will auto bump/adjust the parts loaded on the bed to about 3-5 mm.

  • I would like to nest parts within non-square shapes. Ex. I have a horseshoe shaped part and would like to nest small parts in the center of the u opening.

Is there a setting to open up more customization options for nesting. Is this option or is that just something I have to deal with?