# Cura LE w/ Mini 1 Problem **URL:** \ **Category:** Software\ **Created:** [March 21, 2019, 5:19pm UTC](https://forum.lulzbot.com/t/cura-le-w-mini-1-problem/6603 "2019-03-21T17:19:33Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![Brent.I](https://avatars.discourse-cdn.com/v4/letter/b/ecc23a/32.png) [@Brent.I](https://forum.lulzbot.com/u/Brent.I)\ **Post date:** [March 21, 2019, 9:08pm UTC](https://forum.lulzbot.com/t/cura-le-w-mini-1-problem/6603/2 "2019-03-21T21:08:10Z")
> [@](#): > > Any ideas on how to fix these issues? Crazy timing, I just answered this one on another post! Please see here: [Need a smooth first layer / e-step and z offset woes](https://forum.lulzbot.com/t/need-a-smooth-first-layer-e-step-and-z-offset-woes/6583/1) (Regarding too close to bed) > [@](#): > > The bed slowly moves forward until reaches the end of its movement then comes back to home; happens 3 times at the start of each print. Be sure when installing the new 3.6.3 you clear you cache. We had to make changes to the start gcode to correspond with updated firmware. If you missed clearing the cache, it could be using old start gcode causing some conflicts. If that is not the case, can you reach out to [support@lulzbot.com](mailto:support@lulzbot.com) with a quick video showing the issue? --- _[View the full topic](https://forum.lulzbot.com/t/cura-le-w-mini-1-problem/6603)._