# Error: MINTEMP triggered, system stopped! Heater\_ID: 0

**URL:** <https://forum.lulzbot.com/t/error-mintemp-triggered-system-stopped-heater-id-0/5619>\
**Category:** LulzBot Mini\
**Created:** [February 15, 2018, 2:58am UTC](https://forum.lulzbot.com/t/error-mintemp-triggered-system-stopped-heater-id-0/5619 "2018-02-15T02:58:05Z")\
**Posts on this page:** 1\
**Showing post:** 8

<div class="post-metadata">

**Author:** ![CoParaTech](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/coparatech/32/82_2.png) [@CoParaTech](https://forum.lulzbot.com/u/CoParaTech)\
**Post date:** [February 20, 2018, 11:56pm UTC](https://forum.lulzbot.com/t/error-mintemp-triggered-system-stopped-heater-id-0/5619/8 "2018-02-20T23:56:12Z")

</div>

Well, the good news is the new Rambo works! 😃 So it was the Rambo after all. Flashed the firmware with Cura 2.6.63 and it’s working in Cura. Now to get it working with my Pi2 and Octoprint again. Octoprint can’t detect the baud rate for some reason and won’t connect. I’s always something with these robots…

---

_[View the full topic](https://forum.lulzbot.com/t/error-mintemp-triggered-system-stopped-heater-id-0/5619)._