# flexydually installation - front hot end too low

**URL:** <https://forum.lulzbot.com/t/flexydually-installation-front-hot-end-too-low/3431>\
**Category:** LulzBot TAZ\
**Created:** [May 13, 2016, 2:12am UTC](https://forum.lulzbot.com/t/flexydually-installation-front-hot-end-too-low/3431 "2016-05-13T02:12:11Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![mike.stanley](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/mike.stanley/32/9425_2.png) [@mike.stanley](https://forum.lulzbot.com/u/mike.stanley)\
**Post date:** [May 13, 2016, 2:12am UTC](https://forum.lulzbot.com/t/flexydually-installation-front-hot-end-too-low/3431/1 "2016-05-13T02:12:11Z")

</div>

hi all,

I’m trying to install the flexydually on the taz 5. i’m at the point of homing the Z axis. The front hot end though is significantly lower then the back, even with the front screw all fully tightened. I’m not entirely sure the best way to proceed. should i remove the nut from the front? is this a leveling issue? any help/pointers would be appreciated.

---

<div class="post-metadata">

**Author:** ![mike.stanley](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/mike.stanley/32/9425_2.png) [@mike.stanley](https://forum.lulzbot.com/u/mike.stanley)\
**Post date:** [May 13, 2016, 2:29am UTC](https://forum.lulzbot.com/t/flexydually-installation-front-hot-end-too-low/3431/2 "2016-05-13T02:29:50Z")

</div>

woah. nevermind. adjusting the screw in the other direction helped level it out.