# FlexyDually Issue

**URL:** <https://forum.lulzbot.com/t/flexydually-issue/3374>\
**Category:** Hardware\
**Created:** [April 29, 2016, 6:20pm UTC](https://forum.lulzbot.com/t/flexydually-issue/3374 "2016-04-29T18:20:51Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Zaven4](https://avatars.discourse-cdn.com/v4/letter/z/35a633/32.png) [@Zaven4](https://forum.lulzbot.com/u/Zaven4)\
**Post date:** [April 29, 2016, 6:20pm UTC](https://forum.lulzbot.com/t/flexydually-issue/3374/1 "2016-04-29T18:20:51Z")

</div>

I just bought the V2 Flexydually for my taz 5 with the idea of making parts out of ninjaflex and having ABS/HIPS as support. However all i can seem to do is make everything out of T0 (plastic) or make the part out of plastic and have the rubber (T1) be support. Is there a way to make the second extruder (T1) the primary extruder? Thanks

---

<div class="post-metadata">

**Author:** ![gghouck](https://avatars.discourse-cdn.com/v4/letter/g/a88e4f/32.png) [@gghouck](https://forum.lulzbot.com/u/gghouck)\
**Post date:** [April 29, 2016, 9:25pm UTC](https://forum.lulzbot.com/t/flexydually-issue/3374/2 "2016-04-29T21:25:05Z")

</div>

In slic3r there is a setting for what extruder to use for infill/support/perimeters.

---

<div class="post-metadata">

**Author:** ![kmanley57](https://avatars.discourse-cdn.com/v4/letter/k/13edae/32.png) [@kmanley57](https://forum.lulzbot.com/u/kmanley57)\
**Post date:** [April 30, 2016, 11:40am UTC](https://forum.lulzbot.com/t/flexydually-issue/3374/3 "2016-04-30T11:40:59Z")

</div>

In Cura check out support Dual extrusion, that may give you what you are looking for.