# HOT END DEAD. (FIX IN PROGRESS, GREAT CS) **URL:** \ **Category:** Hardware\ **Created:** [February 6, 2015, 10:04pm UTC](https://forum.lulzbot.com/t/hot-end-dead-fix-in-progress-great-cs/1252 "2015-02-06T22:04:05Z")\ **Posts on this page:** 1\ **Showing post:** 1
**Author:** ![JonathanB](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/jonathanb/32/39_2.png) [@JonathanB](https://forum.lulzbot.com/u/JonathanB)\ **Post date:** [February 6, 2015, 10:04pm UTC](https://forum.lulzbot.com/t/hot-end-dead-fix-in-progress-great-cs/1252/1 "2015-02-06T22:04:05Z")
Went to turn on my printer today to test print a part and the hot end is dead, won’t heat up, the bed heats up fine, no sweat. I’m not too happy, the printer is only a few months old with only moderate usage… what is up with this? I have a few prints I need done for a design challenge, it’s not going to look good when I tell people my Lulzbot printer died after a few months…I expect the hot end to go eventually, but not this soon. I did a quick inspection of the electronics and everything seems ok. I’ve heard mention of small board fuses? not sure about those? Where are they located? I’ve sent an e-mail to support@Lulz. can anyone help with this? thanks. --- _[View the full topic](https://forum.lulzbot.com/t/hot-end-dead-fix-in-progress-great-cs/1252)._