# Ignoring End Stops

**URL:** https://forum.lulzbot.com/t/ignoring-end-stops/3682
**Category:** LulzBot Mini
**Created:** [July 3, 2016, 7:12pm UTC](https://forum.lulzbot.com/t/ignoring-end-stops/3682 "2016-07-03T19:12:55Z")
**Posts on this page:** 1
**Showing post:** 6

<div class="post-metadata">

### Author: ![Biolumo](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/biolumo/32/9340_2.png) [@Biolumo](https://forum.lulzbot.com/u/Biolumo)
#### Post date: [July 6, 2016, 8:49pm UTC](https://forum.lulzbot.com/t/ignoring-end-stops/3682/6 "2016-07-06T20:49:15Z")

</div>

> [@pjones](#):
>
> Thanks everyone for the great advice!
> 
> I decided to start with the M119 command to just figure out what the firmware could see. Both of the X-axis switches and the Z-max switches are reporting correctly. Neither of the Y-axis nor the Z-min switches are reporting at all. I suppose it’s time to take this thing apart and test the switches at the board.
> 
> I’ll let you know what I figure out.

Did you figure anything out? If you have not done so yet i would do a continuity check with a mulimeter of each wire and see if one of the wires to the switch broke or if the switches themselves broke somehow (seems unlikely that two would fail at the same time).

---

_[View the full topic](https://forum.lulzbot.com/t/ignoring-end-stops/3682)._