# Import print profile from Gcode not available in Cura 3.2

**URL:** <https://forum.lulzbot.com/t/import-print-profile-from-gcode-not-available-in-cura-3-2/6172>\
**Category:** Software\
**Created:** [September 12, 2018, 2:54pm UTC](https://forum.lulzbot.com/t/import-print-profile-from-gcode-not-available-in-cura-3-2/6172 "2018-09-12T14:54:30Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![TomsCables](https://avatars.discourse-cdn.com/v4/letter/t/87869e/32.png) [@TomsCables](https://forum.lulzbot.com/u/TomsCables)\
**Post date:** [September 12, 2018, 2:54pm UTC](https://forum.lulzbot.com/t/import-print-profile-from-gcode-not-available-in-cura-3-2/6172/1 "2018-09-12T14:54:30Z")

</div>

Guys,  
I’m hoping you can help me out I am struggling on upgrading from Lulzbot Cura 21.02 to version 3.2 of Cura.

With Version 21.02 and other older versions, I could import the printer setup from the Gcode. I cannot seem to figure this out on the newer versions.

In version 3.2 under Preferences / configure Cura, I selected Profiles and hit the Import button. And selected the Gcode file I wanted to import the setting from. It then informs me the gcode “does not contain any valid profile.”

So I opened version 21.02 and loaded the gcode file the saved the configuration as a Profile.

Trying the Import again in 3.2 it gives the error “Reported version 1 but expected version 2”

So then I bring up Cura 2.6 and try the import again. Thinking that if I can get it to import into version 2 that I can save that profile and import it into version 3.  
With version 2.6 it reports that it imported the profile correctly, but I don’t see any changes on anything. The print temps are still displaying at 200C and not 270C as set in the initial Gcode, even though it reported importing correctly.

What am I missing? How has everyone else handled this?