# Import profile successful but not showing

**URL:** <https://forum.lulzbot.com/t/import-profile-successful-but-not-showing/6530>\
**Category:** Software\
**Created:** [February 23, 2019, 4:26am UTC](https://forum.lulzbot.com/t/import-profile-successful-but-not-showing/6530 "2019-02-23T04:26:28Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Chaffy](https://avatars.discourse-cdn.com/v4/letter/c/71e660/32.png) [@Chaffy](https://forum.lulzbot.com/u/Chaffy)\
**Post date:** [February 23, 2019, 4:26am UTC](https://forum.lulzbot.com/t/import-profile-successful-but-not-showing/6530/1 "2019-02-23T04:26:28Z")

</div>

I am following the steps in this thread: [https://forum.lulzbot.com/t/using-cura-2-3-1-with-lulzbot-3d-printers/4158/1](https://forum.lulzbot.com/t/using-cura-2-3-1-with-lulzbot-3d-printers/4158/1)  
I am using the PLA\_medium-quality\_TAZ\_single-extruder\_0.35noz\_cura.ini profile I downloaded from the link provided in the thread. When I import the profile it says it was successful but I don’t see it as a profile option. I’m using Cura 2.6.52. I tried with cura 3.2.32 but the profile failed to load with an error about version 1 expecting version 2.

I have a Taz 2 that I’m trying to setup basically from scratch. I’ve been having various issues with prints so I figured starting from scratch with this profile was a good clean slate rather than chase my tail around.

---

<div class="post-metadata">

**Author:** ![Chaffy](https://avatars.discourse-cdn.com/v4/letter/c/71e660/32.png) [@Chaffy](https://forum.lulzbot.com/u/Chaffy)\
**Post date:** [February 27, 2019, 12:53am UTC](https://forum.lulzbot.com/t/import-profile-successful-but-not-showing/6530/2 "2019-02-27T00:53:04Z")

</div>

I ended up downloading 2.3.1… The profile loaded, hoping this first print works out.