# Lulz mini 1 stuck during bed leveling

**URL:** <https://forum.lulzbot.com/t/lulz-mini-1-stuck-during-bed-leveling/6477>\
**Category:** Software\
**Created:** [February 4, 2019, 7:11pm UTC](https://forum.lulzbot.com/t/lulz-mini-1-stuck-during-bed-leveling/6477 "2019-02-04T19:11:04Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Dsiracusan](https://avatars.discourse-cdn.com/v4/letter/d/eb8c5e/32.png) [@Dsiracusan](https://forum.lulzbot.com/u/Dsiracusan)\
**Post date:** [February 4, 2019, 7:11pm UTC](https://forum.lulzbot.com/t/lulz-mini-1-stuck-during-bed-leveling/6477/1 "2019-02-04T19:11:04Z")

</div>

My mini is having problems as of yesterday. It will manually move in all directions through the cura program. When I go to print it will proceed as normal until the bed leveling where after leveling the first washer it will begin to move to the second and freeze part of the way and just hang there indefinitely. I have tried deleting caches and updating the firmware but it is still having this issue no matter what I try. If you have any advice on where to start I’m all ears

---

<div class="post-metadata">

**Author:** ![Dsiracusan](https://avatars.discourse-cdn.com/v4/letter/d/eb8c5e/32.png) [@Dsiracusan](https://forum.lulzbot.com/u/Dsiracusan)\
**Post date:** [February 4, 2019, 7:14pm UTC](https://forum.lulzbot.com/t/lulz-mini-1-stuck-during-bed-leveling/6477/2 "2019-02-04T19:14:56Z")

</div>

I have gone through moving of the bed plate manually again and occasionally it stops moving and will not respond and I have to disconnect it and reconnect through cura for it to move again

---

<div class="post-metadata">

**Author:** ![ritmopat](https://avatars.discourse-cdn.com/v4/letter/r/dc4da7/32.png) [@ritmopat](https://forum.lulzbot.com/u/ritmopat)\
**Post date:** [February 24, 2019, 11:36am UTC](https://forum.lulzbot.com/t/lulz-mini-1-stuck-during-bed-leveling/6477/3 "2019-02-24T11:36:13Z")

</div>

did you figure it out yet?