# Nozzle misses wiper pad and gcode adjustment not applied

**URL:** <https://forum.lulzbot.com/t/nozzle-misses-wiper-pad-and-gcode-adjustment-not-applied/26908>\
**Category:** LulzBot TAZ\
**Created:** [August 24, 2024, 6:09pm UTC](https://forum.lulzbot.com/t/nozzle-misses-wiper-pad-and-gcode-adjustment-not-applied/26908 "2024-08-24T18:09:05Z")\
**Posts on this page:** 1\
**Showing post:** 13

<div class="post-metadata">

**Author:** ![ksattic](https://avatars.discourse-cdn.com/v4/letter/k/7feea3/32.png) [@ksattic](https://forum.lulzbot.com/u/ksattic)\
**Post date:** [August 28, 2024, 12:28pm UTC](https://forum.lulzbot.com/t/nozzle-misses-wiper-pad-and-gcode-adjustment-not-applied/26908/13 "2024-08-28T12:28:25Z")

</div>

Yeah, the Marlin definition could certainly be clearer, although I’ve seen otherLulzbot printers use the new home location immediately rather than wait for rehoming (there was a thread somewhere on this forum showing a dump from the console). Edit: [found it](https://forum.lulzbot.com/t/centering-bed-for-calibration/21683/22).

In the end I did M206 X3 and then M500 to store the new position (I checked, and previously it had X=0). This also centres my print correctly for the first time. It’s like my printer geometry is off a little.

---

_[View the full topic](https://forum.lulzbot.com/t/nozzle-misses-wiper-pad-and-gcode-adjustment-not-applied/26908)._