# Post Cleaning/Prep of PEI Bed on TAZ 6

**URL:** <https://forum.lulzbot.com/t/post-cleaning-prep-of-pei-bed-on-taz-6/3863>\
**Category:** LulzBot TAZ\
**Created:** [August 15, 2016, 8:28pm UTC](https://forum.lulzbot.com/t/post-cleaning-prep-of-pei-bed-on-taz-6/3863 "2016-08-15T20:28:29Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![njgsx96](https://avatars.discourse-cdn.com/v4/letter/n/3e96dc/32.png) [@njgsx96](https://forum.lulzbot.com/u/njgsx96)\
**Post date:** [August 15, 2016, 8:28pm UTC](https://forum.lulzbot.com/t/post-cleaning-prep-of-pei-bed-on-taz-6/3863/1 "2016-08-15T20:28:29Z")

</div>

Gents and Ladies,

Was curious. After printing with t-glase or Ninjaflex, or any material that requires putting down glue stick for the print, what is the proper cleanup procedure on a TAZ 6 PEI glass? Is it safe to scrape the residue and then do final cleanup or do not scrape the bed at all? Wasn’t sure if the glass is treated or simply glass and whether it was OK or not to scrape it clean with a putty knife.

Thanks, Rich

---

<div class="post-metadata">

**Author:** ![mbaldwin](https://avatars.discourse-cdn.com/v4/letter/m/da6949/32.png) [@mbaldwin](https://forum.lulzbot.com/u/mbaldwin)\
**Post date:** [August 15, 2016, 9:07pm UTC](https://forum.lulzbot.com/t/post-cleaning-prep-of-pei-bed-on-taz-6/3863/2 "2016-08-15T21:07:56Z")

</div>

Hello,

I recommend using warm water with a soft cloth to clean glue off the PEI.

---

<div class="post-metadata">

**Author:** ![njgsx96](https://avatars.discourse-cdn.com/v4/letter/n/3e96dc/32.png) [@njgsx96](https://forum.lulzbot.com/u/njgsx96)\
**Post date:** [August 15, 2016, 10:53pm UTC](https://forum.lulzbot.com/t/post-cleaning-prep-of-pei-bed-on-taz-6/3863/3 "2016-08-15T22:53:30Z")

</div>

You got it! Thanks for the response!