Apologies for not know the exact terminology for this.
I"m new to Lulzbot and just purchased a TAZ 5. I’ve been a cubex duo user for a couple of years and while through hacking and using KISSlicer was able to achieve good prints. It could never be used beyond that boundary.
I’m loving this printer and have used simplify3D and cura. The one problem i seem to have is that when beginning a print, the extruder never does a pre-extrude and thus every time it starts printing, nothing comes out for the first 2-3 seconds. On my cubex, before printing it would go the very back of the printer and let a few seconds of filament come out into a bin, then move over and start printing. Am I missing something in the programs i’m using, or is this just something that Lulzbot doesn’t do?