# Print to Tall - Split Print

**URL:** <https://forum.lulzbot.com/t/print-to-tall-split-print/1093>\
**Category:** Software\
**Created:** [December 23, 2014, 4:30pm UTC](https://forum.lulzbot.com/t/print-to-tall-split-print/1093 "2014-12-23T16:30:06Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Theycallmejohn](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/theycallmejohn/32/17_2.png) [@Theycallmejohn](https://forum.lulzbot.com/u/Theycallmejohn)\
**Post date:** [December 23, 2014, 4:30pm UTC](https://forum.lulzbot.com/t/print-to-tall-split-print/1093/1 "2014-12-23T16:30:06Z")

</div>

Hey All,  
Is there a way in Slic3r or Cura to split the print if it is too tall into two STLs? If not is there another program that can do it with STLs?

John

---

<div class="post-metadata">

**Author:** ![prstein](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/prstein/32/36_2.png) [@prstein](https://forum.lulzbot.com/u/prstein)\
**Post date:** [December 23, 2014, 4:52pm UTC](https://forum.lulzbot.com/t/print-to-tall-split-print/1093/2 "2014-12-23T16:52:03Z")

</div>

Hi John,

I use Slic3r as a standalone program, not from within Pronterface or anything. So in that, on the Plater tab, there is a button along the top marked view/cut. Also gives you the option of just keeping one or the other of the pieces, and to rotate the lower piece (so the cut part is against the bed).

Best Regards,  
Paul