Printing thin wall model

General LulzBot Mini
1

I

039(1)-750x560
039(1)-750x560750×560 48.5 KB

I need to print these signal heads. I have a Mini and the new 0.25 nozzle. The attached image shows some model signals like I want to print. As you can tell the Hoods on relatively thin. For my scale they are about 3mm or so round. The thickness of the walls would be best if .5 or .75 thick. I have the circuit boards simular to these.

Thanks

Jay

2

I would think that .75 would be possible. Ideally the wall thickness should be designed to be a multiple of the extrusion width. In the slicer preview, check that the walls are two extrusion (of .3mm) for an approximate wall thickness of .6mm.