# Prints start off the bed **URL:** \ **Category:** LulzBot Mini\ **Created:** [August 31, 2018, 11:06am UTC](https://forum.lulzbot.com/t/prints-start-off-the-bed/6135 "2018-08-31T11:06:43Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![Magnoguido](https://avatars.discourse-cdn.com/v4/letter/m/e9bcb4/32.png) [@Magnoguido](https://forum.lulzbot.com/u/Magnoguido)\ **Post date:** [August 31, 2018, 11:06am UTC](https://forum.lulzbot.com/t/prints-start-off-the-bed/6135/1 "2018-08-31T11:06:43Z")
The Lulzbot does the proper set up; Goes to home position Cleans nozzle Calibrates the 4 points without no issues Then when the printing begins it sometimes starts the print off the bed. Right over the nozzle cleaning pad to be exact. Advice? ---
**Author:** ![Galadriel](https://avatars.discourse-cdn.com/v4/letter/g/c89c15/32.png) [@Galadriel](https://forum.lulzbot.com/u/Galadriel)\ **Post date:** [August 31, 2018, 12:57pm UTC](https://forum.lulzbot.com/t/prints-start-off-the-bed/6135/2 "2018-08-31T12:57:27Z")
Could we get a bit more information to help narrow down what might be happening? What type of printer are you using? Are you printing through the USB or an SD card? If your printing through an SD card have you made sure that the GCode is sliced for the version of software/firmware you are currently using? Have you seen this occur across a variety of models? Once we know a bit more we should be able to help you narrow down what is happening. My first thoughts will be something software related. ---
**Author:** ![Magnoguido](https://avatars.discourse-cdn.com/v4/letter/m/e9bcb4/32.png) [@Magnoguido](https://forum.lulzbot.com/u/Magnoguido)\ **Post date:** [August 31, 2018, 5:02pm UTC](https://forum.lulzbot.com/t/prints-start-off-the-bed/6135/3 "2018-08-31T17:02:11Z")
Using a Lulzbot Mini Printing via USB and the CURA software. Windows 7 proff. Latest drivers installed.