# Removing threaded extension on Budashnozzle1.0

**URL:** <https://forum.lulzbot.com/t/removing-threaded-extension-on-budashnozzle1-0/6875>\
**Category:** Hardware\
**Created:** [August 27, 2019, 3:14am UTC](https://forum.lulzbot.com/t/removing-threaded-extension-on-budashnozzle1-0/6875 "2019-08-27T03:14:42Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![ScottTorres](https://avatars.discourse-cdn.com/v4/letter/s/a9a28c/32.png) [@ScottTorres](https://forum.lulzbot.com/u/ScottTorres)\
**Post date:** [August 27, 2019, 3:14am UTC](https://forum.lulzbot.com/t/removing-threaded-extension-on-budashnozzle1-0/6875/1 "2019-08-27T03:14:42Z")

</div>

I had a problem similar to other users with mangled threads on nozzle after not removing easily. Now I need to replace the threaded extension as well as the nozzle. However, I cannot get the threaded extension to remove from the heater block. Any ideas or suggestions? I am almost ready to replace the whole Budashnozzle, but would like to avoid it if possible.

Thanks.

---

<div class="post-metadata">

**Author:** ![Orias](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/orias/32/3_2.png) [@Orias](https://forum.lulzbot.com/u/Orias)\
**Post date:** [August 27, 2019, 8:48pm UTC](https://forum.lulzbot.com/t/removing-threaded-extension-on-budashnozzle1-0/6875/2 "2019-08-27T20:48:34Z")

</div>

Hmm, does your Buda look like this? [https://reprap.org/wiki/Budaschnozzle/1.0](https://reprap.org/wiki/Budaschnozzle/1.0)

Are you sure it’s a 1.0, with a nozzle like this? [http://download.lulzbot.com/Budaschnozzle/v1.0/Nozzle.PDF](http://download.lulzbot.com/Budaschnozzle/v1.0/Nozzle.PDF) or does the nozzle look like: [http://download.lulzbot.com/Budaschnozzle/v1.1/Nozzle%20V1.1.1.PDF](http://download.lulzbot.com/Budaschnozzle/v1.1/Nozzle%20V1.1.1.PDF) ?