# Skip Auto-Leveling between multiple prints?

**URL:** <https://forum.lulzbot.com/t/skip-auto-leveling-between-multiple-prints/3030>\
**Category:** LulzBot Mini\
**Created:** [February 28, 2016, 2:20pm UTC](https://forum.lulzbot.com/t/skip-auto-leveling-between-multiple-prints/3030 "2016-02-28T14:20:29Z")\
**Posts on this page:** 1\
**Showing post:** 1

<div class="post-metadata">

**Author:** ![egus](https://avatars.discourse-cdn.com/v4/letter/e/e95f7d/32.png) [@egus](https://forum.lulzbot.com/u/egus)\
**Post date:** [February 28, 2016, 2:20pm UTC](https://forum.lulzbot.com/t/skip-auto-leveling-between-multiple-prints/3030/1 "2016-02-28T14:20:29Z")

</div>

I am printing multiple parts in multiple print runs consecutively on the Mini with default firmware. I am running S3D but have the start and end gcode generated from Cura included.

Can the auto-bed leveling check be skipped after the first print since nothing is changing between setup/prints? The machine is not power cycled or disturbed between print runs so I would think the Z-height would be correct upon restart.

```nohighlight
M109 S140 ; set to probing temp
M204 S300 ; Set probing acceleration
G29 ; Probe

```

I tried just commenting out the probing code but my Z level seems to be off every time it goes to print after that code.  
Is there ending code that needs to be tweaked? (its the stock start/end code from Cura prints)

---

_[View the full topic](https://forum.lulzbot.com/t/skip-auto-leveling-between-multiple-prints/3030)._