# Slic3r Profiles and Start/Stop Code

**URL:** <https://forum.lulzbot.com/t/slic3r-profiles-and-start-stop-code/4092>\
**Category:** Software\
**Created:** [October 10, 2016, 9:29pm UTC](https://forum.lulzbot.com/t/slic3r-profiles-and-start-stop-code/4092 "2016-10-10T21:29:01Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![mrmatt68](https://avatars.discourse-cdn.com/v4/letter/m/e47c2d/32.png) [@mrmatt68](https://forum.lulzbot.com/u/mrmatt68)\
**Post date:** [October 10, 2016, 9:29pm UTC](https://forum.lulzbot.com/t/slic3r-profiles-and-start-stop-code/4092/1 "2016-10-10T21:29:01Z")

</div>

Hi,

I am trying to use slic3r to generate the G-code and send to octopi and while it sends a file when it prints it homes z then wipes and then does the bed level routine and stops. I added the start/stop codes from cura to slic3r so it should be doing that but why is it not running the part? The file is 110 Megs. I downloaded the profiles in ABS to slic3r and setup everything that made sense but i cannot seem to get a part to actually run. Do i need to setup the start stop g-code in octoprint?

Thanks,

Matt