# Taz 3 y axis skipping steps?

**URL:** <https://forum.lulzbot.com/t/taz-3-y-axis-skipping-steps/528>\
**Category:** LulzBot TAZ\
**Created:** [March 25, 2014, 3:34pm UTC](https://forum.lulzbot.com/t/taz-3-y-axis-skipping-steps/528 "2014-03-25T15:34:23Z")\
**Posts on this page:** 1\
**Showing post:** 5

<div class="post-metadata">

**Author:** ![Curlnizzle](https://avatars.discourse-cdn.com/v4/letter/c/5fc32e/32.png) [@Curlnizzle](https://forum.lulzbot.com/u/Curlnizzle)\
**Post date:** [March 29, 2014, 4:53pm UTC](https://forum.lulzbot.com/t/taz-3-y-axis-skipping-steps/528/5 "2014-03-29T16:53:38Z")

</div>

[http://imgur.com/Pf4eSZ1](http://imgur.com/Pf4eSZ1)  
Good call, after I looked and followed the sounds I found this for my y motor. The pulley has slide down on the shaft, rubbed my belt down a little bit. You can see the build up of rubber shavings. I cleaned them up and slid it back up the collar, problem fixed.

---

_[View the full topic](https://forum.lulzbot.com/t/taz-3-y-axis-skipping-steps/528)._