# TAZ 5 Bed Leveling Corners

**URL:** <https://forum.lulzbot.com/t/taz-5-bed-leveling-corners/6790>\
**Category:** Hardware\
**Created:** [July 7, 2019, 10:08pm UTC](https://forum.lulzbot.com/t/taz-5-bed-leveling-corners/6790 "2019-07-07T22:08:10Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![adamtimm1](https://avatars.discourse-cdn.com/v4/letter/a/db5fbb/32.png) [@adamtimm1](https://forum.lulzbot.com/u/adamtimm1)\
**Post date:** [July 7, 2019, 10:08pm UTC](https://forum.lulzbot.com/t/taz-5-bed-leveling-corners/6790/1 "2019-07-07T22:08:10Z")

</div>

I hate the bed leveling corners on my TAZ 5 because they “float.” As I adjust, the front of the corners may be lower than the screws adjust them to. It’s like a guy pulling his hat down over his eyes and I often have to tilt the leveling corner backwards to get the corner to actually be level. I hope someone understands this.

I have designed and printed (and included) other corners but they take up a lot more of my bed edge. I would like to come up with a single “dial in” leveling screw which would lift the bed straight up and not “nod” forward. I don’t like the Allen Screws although I have figured out how much to turn the wrench to get in a few microns of difference.

Yeh, I know about auto leveling etc. but I want to keep this cheap. I saw one method a bit ago but I needed to see more of it to see if I can make it. Any ideas folks?

I figure since there are 3 drill holes on the aluminum bed there has to be another way. I just don’t want to get into adjusting 2 screws per corner.  
[Taz5\_2pt\_bed\_corner.stl](https://forum.lulzbot.com/uploads/short-url/uQn6g7E9dVDLvH0arZ4qMIxvKiH.stl) (108 KB)