# TAZ 5 y axis homing Issue **URL:** \ **Category:** LulzBot TAZ\ **Created:** [October 20, 2025, 8:51pm UTC](https://forum.lulzbot.com/t/taz-5-y-axis-homing-issue/27759 "2025-10-20T20:51:56Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![PrinterLord](https://avatars.discourse-cdn.com/v4/letter/p/8c91f0/32.png) [@PrinterLord](https://forum.lulzbot.com/u/PrinterLord)\ **Post date:** [October 20, 2025, 8:51pm UTC](https://forum.lulzbot.com/t/taz-5-y-axis-homing-issue/27759/1 "2025-10-20T20:51:57Z")
When I home my TAZ 5 3d printer it homes normally for the x axis, and z axis, however when it’s time for the y axis to home it moves away from the limit switch and jitters against the end of the rail for around five seconds before stopping and returning a error that goes as “Printer Error, Homing Failed, Please reset.” I was wondering if anybody knows what could cause this issue, as I’m unable to puzzle out what the issue could be. Thank you for your help! ---
**Author:** ![Wrathernaut](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/wrathernaut/32/13542_2.png) [@Wrathernaut](https://forum.lulzbot.com/u/Wrathernaut)\ **Post date:** [October 20, 2025, 9:03pm UTC](https://forum.lulzbot.com/t/taz-5-y-axis-homing-issue/27759/2 "2025-10-20T21:03:24Z")
Does it move the correct direction when you move it manually from the movement menu, or reversed? The bed should move away from you as you lower the Y coordinate. If it’s not doing that, it’s wired wrong. If it does move correctly with manual movements, it’s a firmware issue. ---
**Author:** ![PrinterLord](https://avatars.discourse-cdn.com/v4/letter/p/8c91f0/32.png) [@PrinterLord](https://forum.lulzbot.com/u/PrinterLord)\ **Post date:** [October 21, 2025, 8:23pm UTC](https://forum.lulzbot.com/t/taz-5-y-axis-homing-issue/27759/3 "2025-10-21T20:23:16Z")
Thank you, I’ll check the wiring.