# Taz 6 autoleveling does not touch plates

**URL:** <https://forum.lulzbot.com/t/taz-6-autoleveling-does-not-touch-plates/24043>\
**Category:** Community\
**Created:** [December 28, 2021, 5:27pm UTC](https://forum.lulzbot.com/t/taz-6-autoleveling-does-not-touch-plates/24043 "2021-12-28T17:27:41Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![kdryan](https://avatars.discourse-cdn.com/v4/letter/k/8e8cbc/32.png) [@kdryan](https://forum.lulzbot.com/u/kdryan)\
**Post date:** [December 28, 2021, 5:27pm UTC](https://forum.lulzbot.com/t/taz-6-autoleveling-does-not-touch-plates/24043/1 "2021-12-28T17:27:41Z")

</div>

So when I go to autolevel the bed, the probe will touch the back two plates, but barely miss the front two. Is there a way to adjust this at all?

---

<div class="post-metadata">

**Author:** ![Syncman](https://avatars.discourse-cdn.com/v4/letter/s/ee59a6/32.png) [@Syncman](https://forum.lulzbot.com/u/Syncman)\
**Post date:** [January 3, 2022, 9:59pm UTC](https://forum.lulzbot.com/t/taz-6-autoleveling-does-not-touch-plates/24043/2 "2022-01-03T21:59:32Z")

</div>

Our taz was missing the RHS front. . A turn of the RHS stepper lowered the nozzle to where it touches again.