# Taz 6 E3D

**URL:** <https://forum.lulzbot.com/t/taz-6-e3d/4021>\
**Category:** LulzBot TAZ\
**Created:** [September 22, 2016, 3:51pm UTC](https://forum.lulzbot.com/t/taz-6-e3d/4021 "2016-09-22T15:51:44Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![CJay](https://avatars.discourse-cdn.com/v4/letter/c/e68b1a/32.png) [@CJay](https://forum.lulzbot.com/u/CJay)\
**Post date:** [September 22, 2016, 3:51pm UTC](https://forum.lulzbot.com/t/taz-6-e3d/4021/1 "2016-09-22T15:51:44Z")

</div>

just a quick question - If i were to upgrade the hotend to the e3d v6 is the overall process the same for the Taz 5 extruder or is it a bit more complicated (other than the autolevel sensor). Here’s the guide on the Taz 5 conversion. [http://matterhackers.dozuki.com/Guide/How+to+Install+an+E3D+v6+HotEnd+on+a+Lulzbot+TAZ+5/5](http://matterhackers.dozuki.com/Guide/How+to+Install+an+E3D+v6+HotEnd+on+a+Lulzbot+TAZ+5/5)

---

<div class="post-metadata">

**Author:** ![CJay](https://avatars.discourse-cdn.com/v4/letter/c/e68b1a/32.png) [@CJay](https://forum.lulzbot.com/u/CJay)\
**Post date:** [September 22, 2016, 3:58pm UTC](https://forum.lulzbot.com/t/taz-6-e3d/4021/2 "2016-09-22T15:58:22Z")

</div>

Oh and I guess which hot end voltage am I looking at - not sure about the heater block voltage