# Taz 6, Modular Bed, Aerostruder, compressed prints issue

**URL:** <https://forum.lulzbot.com/t/taz-6-modular-bed-aerostruder-compressed-prints-issue/26571>\
**Category:** General\
**Created:** [April 18, 2024, 6:21pm UTC](https://forum.lulzbot.com/t/taz-6-modular-bed-aerostruder-compressed-prints-issue/26571 "2024-04-18T18:21:37Z")\
**Posts on this page:** 1\
**Showing post:** 10

<div class="post-metadata">

**Author:** ![drd1969](https://avatars.discourse-cdn.com/v4/letter/d/f08c70/32.png) [@drd1969](https://forum.lulzbot.com/u/drd1969)\
**Post date:** [April 19, 2024, 12:56am UTC](https://forum.lulzbot.com/t/taz-6-modular-bed-aerostruder-compressed-prints-issue/26571/10 "2024-04-19T00:56:08Z")

</div>

You both totally NAILED IT.

Thank you so much.

Setting the fade to zero under motion in Marlin 2.1 eliminated the squish. It was driving me nuts.

I do not understand why the value of 10 worked with the original bed and the +1.5mm shift resulted in the ~8mm value of squish. I might play around with values of 5,4,3, 2, and 1 to see if there is any noticeable value to the option at all.

Again thank you

Brian

---

_[View the full topic](https://forum.lulzbot.com/t/taz-6-modular-bed-aerostruder-compressed-prints-issue/26571)._