# Taz 6 specific Openbuilds X axis

**URL:** <https://forum.lulzbot.com/t/taz-6-specific-openbuilds-x-axis/3787>\
**Category:** Hardware\
**Created:** [July 29, 2016, 5:33am UTC](https://forum.lulzbot.com/t/taz-6-specific-openbuilds-x-axis/3787 "2016-07-29T05:33:38Z")\
**Posts on this page:** 1\
**Showing post:** 27

<div class="post-metadata">

**Author:** ![piercet](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/piercet/32/12_2.png) [@piercet](https://forum.lulzbot.com/u/piercet)\
**Post date:** [September 30, 2017, 11:37pm UTC](https://forum.lulzbot.com/t/taz-6-specific-openbuilds-x-axis/3787/27 "2017-09-30T23:37:35Z")

</div>

> [@](#):
>
> Couple pics showing the X max switch tabs alignment.  
> 20170914\_175027.jpg
> 
> 20170914\_175017.jpg
> 
> I had to cut off the front mount because of the bottom part (widest bit) of the carriage fouled and stopped it from getting as close.

Ok, i finally figured out what occured here. You used the version 1 pieces, which are misalligned. The Version 2 pieces here: [Adjustable heat bed - glass mount](https://forum.lulzbot.com/t/adjustable-heat-bed-glass-mount/38/1) should be correct. See if those do the trick. if not, I can adjust them as needed.

---

_[View the full topic](https://forum.lulzbot.com/t/taz-6-specific-openbuilds-x-axis/3787)._