# Taz 6 - Y Axis loud noise

**URL:** <https://forum.lulzbot.com/t/taz-6-y-axis-loud-noise/24711>\
**Category:** Hardware\
**Created:** [July 22, 2022, 11:42am UTC](https://forum.lulzbot.com/t/taz-6-y-axis-loud-noise/24711 "2022-07-22T11:42:23Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![Wrathernaut](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/wrathernaut/32/13542_2.png) [@Wrathernaut](https://forum.lulzbot.com/u/Wrathernaut)\
**Post date:** [July 22, 2022, 5:03pm UTC](https://forum.lulzbot.com/t/taz-6-y-axis-loud-noise/24711/2 "2022-07-22T17:03:21Z")

</div>

Check this thread, the firmware at the end will swap the E1 and Y axis drivers, so you can at least rule out the driver: [Taz 6 axis grinding - General / LulzBot TAZ - Lulzbot](https://forum.lulzbot.com/t/taz-6-axis-grinding/24658/19)

If that doesn’t solve it, try running the motor while not attached to the axis as well to rule out the axis itself as an issue.

---

_[View the full topic](https://forum.lulzbot.com/t/taz-6-y-axis-loud-noise/24711)._