# Taz Pro - Homing fails on Y axis **URL:** \ **Category:** General\ **Created:** [December 12, 2023, 6:53pm UTC](https://forum.lulzbot.com/t/taz-pro-homing-fails-on-y-axis/26245 "2023-12-12T18:53:59Z")\ **Posts on this page:** 4\ **Page:** 1
**Author:** ![joejuan](https://avatars.discourse-cdn.com/v4/letter/j/ce73a5/32.png) [@joejuan](https://forum.lulzbot.com/u/joejuan)\ **Post date:** [December 12, 2023, 6:53pm UTC](https://forum.lulzbot.com/t/taz-pro-homing-fails-on-y-axis/26245/1 "2023-12-12T18:53:59Z")
Taz Pro Runing CuraLE 4.13.1, firmware 2.1.3.0.18 Earlier today I updated the firmware via CuraLE. Now printer is failing to home along the Y axis. Bed moves, hits the stops but the belts continue to run until the sad tone plays and I get the Homing Failed message. I can manually home the X and Z axis from the LCD. If I manually home the Y axis, bed moves forward to the stops and the motors/belt continue moving. Any ideas? ---
**Author:** ![Wrathernaut](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/wrathernaut/32/13542_2.png) [@Wrathernaut](https://forum.lulzbot.com/u/Wrathernaut)\ **Post date:** [December 12, 2023, 7:02pm UTC](https://forum.lulzbot.com/t/taz-pro-homing-fails-on-y-axis/26245/2 "2023-12-12T19:02:01Z")
Try adjusting the sensorless homing sensitivity. ---
**Author:** ![joejuan](https://avatars.discourse-cdn.com/v4/letter/j/ce73a5/32.png) [@joejuan](https://forum.lulzbot.com/u/joejuan)\ **Post date:** [December 12, 2023, 8:04pm UTC](https://forum.lulzbot.com/t/taz-pro-homing-fails-on-y-axis/26245/3 "2023-12-12T20:04:42Z")
Went from 4 down to 3 under sensor less homing, and it homed the Y axis successfully. Thanks for the help, jj ---
**Author:** ![Seconds2go](https://avatars.discourse-cdn.com/v4/letter/s/3d9bf3/32.png) [@Seconds2go](https://forum.lulzbot.com/u/Seconds2go)\ **Post date:** [September 28, 2026, 7:52pm UTC](https://forum.lulzbot.com/t/taz-pro-homing-fails-on-y-axis/26245/5 "2026-09-28T19:52:37Z")
_THANK YOU!_ Fixed my PRO Y axis problem immediately! 😀